Ways To Danbury Homeowner Can Easily Do Garbage Disposal Repair
Many are opting to do garbage disposal repairs in Danbury, CT on themselves, rather than calling in a plumber. It is one way to save money on common issues that pop up that usually only require a few simple steps to take care of. All that you need is a little knowledge of your disposal and the right set of tools.
Usually, you can repair garbage disposal problems quickly at your Danbury home with the right tools and precautions. Most common problems can be taken care of without calling in a plumber or electrician. All you need to be sure of is to have the right tools and to know what the problem is before you start.
Before working on a problem with your machine, you must turn off the power for safety reasons. Once that is done, gather up a few tools that you may need like, a turning tool, a bucket, some metal tongs, a pipe wrench, a screwdriver, and a snake or auger. A broomstick can be used in the place of a turning tool. Just remember that when working on one, keep your hands out of it.
If you have something stuck in your machine, you need to plan how to get it out. First check the inside drain, if you see something, use your metal tongs to get it out. Sometimes you need to go under the machine to the hole at the bottom and manually turn it. Use your turning tool or broom handle by inserting it into the hole and moving the machine back and forth, which should loosen up whatever is stuck.
If a slow drain is a problem, you may have a clog somewhere. The worst thing to do is use a chemical drain cleaner as that may damage your disposal. Therefore, you’ll need to check the trap and clean that if necessary, have your bucket ready when you take the trap off to catch water and any obstructions. If the problem is not in the trap, it is likely in the drainpipe, and you clean that out with your auger or snake.
If there is a leak, it is usually in one of three places. First, check the screws on the drainage pipe and tighten if necessary. Next, check the bolts that mount the machine to make sure they are tight. Finally, it may be necessary to replace or add more plumbers putty to where the disposal meets the sink.
Machines can get overloaded at times and need a reset. If you find your machine not working at all, it most likely just needs to be reset. In most models, the reset button is underneath. Once you locate it, just press and that should fix the problem. If it doesn’t, it could be wiring or cord problems.
It isn’t uncommon to see problems such as clogs, jams, and leaks. It is important that when you do the Danbury garbage disposal repair yourself to take precautions and to be sure of what you are doing. If anything is beyond your expertise, there is no shame in calling an expert in.